Shark 100B Specifikace stáhnout pdf (Strana 52)

Electro Industries/GaugeTech

Doc #: E145701 5-2

5.1.2:

RS-4485

Communication

Com

(485

Option)

The Shark 100 meter’s RS-485 port uses standard 2-Wire, Half Duplex Architecture.

The RS-485 connector is located on the terminal section of the Shark 100. A connection can easily

be made to a Master Device or to other Slave Devices, as shown below.

Care should be taken to connect + to + and - to - connections.

The Shark 100 meter’s RS-485 can be programmed with the buttons on the face of the meter or by

using Communicator EXT 3.0 software.

Standard RS-485 Port Settings:

Address: 001 to 247

Baud Rate: 9600, 19200, 38400 or 57600

Protocol: Modbus RTU, Modbus ASCII, DNP 3.0 (V3 and V4 Only)

NOTE: This option is not currently available.

The RS-485 Option is combined with Pulse Output in the RS-485P Option. (See section 5.1.3.)

Figure 5.2: RS-485 Communication Installation

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 113 114

Žádné komentáře

Shark 100B Specifikace Strana 52